 |
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
| Datasheet File OCR Text: |
| THE CONNOR-WINFIELD CORP. 2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 851-5040. PHONE (630) 851-4722. www.conwin.com PRODUCT D ATA SHEET CRYSTAL CONTROLLED OSCILLATORS CW 0107 BSOV3S3 12.80M SURFACE MOUNT 3.3V HCMOS STRATUM 3 OCXO ABSOLUTE MAXIMUM RATINGS PARAMETER Storage Temperature Supply Voltage Control Voltage OPERATING SPECIFICATIONS PARAMETER Center Frequency Frequency Calibration, Vc=1.59 Vdc Frequency Stability Aging (Daily) Aging (20 Years) Total Frequency Tolerance Operating Temperature Range Supply Voltage Supply Current Phase Jitter (BW=12KHz to 20MHz) Phase Jitter (BW=10Hz to 20MHz) Period Jitter SSB Phase Noise at 10Hz offset SSB Phase Noise at 10KHz offset Warm Up Time TDEV @ 1.0 Sec. TDEV @ 4.0 Sec. INTPUT CHARACTERISTICS PARAMETER Control Voltage Range Frequency at Vc=0.3 Vdc Frequency at Vc=3.0 Vdc Slope of Frequency Adjust Input Impedance HCMOS OUTPUT CHARACTERISTICS PARAMETER LOAD Voltage (High) (Low) Current (High) (Low) Duty Cycle at 50% of Vcc Rise / Fall Time 10% to 90% PACKAGE CHARACTERISTICS Package (Voh) (Vol) (Ioh) (Ioh) MINIMUM 2.6 -4 45 NOMINAL 50 MAXIMUM 15 0.4 4 55 6 UNITS pf Vdc Vdc mA mA % nS (Vc) MINIMUM 0.3 -38 25 18.5 100k NOMINAL 1.59 MAXIMUM 3.0 -25 38 UNITS Vdc ppm ppm ppm/V Ohm TABLE 4.0 NOTE 6 6 (Vcc) (Icc) (Fo) MINIMUM 1.544 -1.5 -0.25 -30 -2.5 -4.6 0 3.135 3.3 -90 -135 NOMINAL MAXIMUM 20.0 1.5 0.25 30 2.5 4.6 70 3.465 450 1 3 5 5 1 2 UNITS MHz ppm ppm ppb ppm ppm C Vdc mA ps rms ps rms ps rms dBc/Hz dBc/Hz Minutes nS nS 1 2 3 4 UNITS (Vcc) (Vc) MINIMUM -40 -0.5 -0.5 NOMINAL MAXIMUM 85 4.5 4.5 UNITS C Vdc Vdc TABLE 2.0 NOTE TABLE 1.0 NOTE BSOV3S3 DESCRIPTION The Connor-Winfield BSOV3S3 is a true Surface Mount 3.3V, Voltage Controlled Oven Controlled Crystal Oscillator (VCOCXO) with an HCMOS output. The BSOV3S3 is designed for Stratum 3 applications requiring high pullability, tight frequency stability and low jitter. 5 TABLE 3.0 NOTE FEATURES FREQUENCY ADJUST 3.3V OPERATION LOW JITTER <1pS RMS TEMPERATURE STABILITY 0.25ppm FREQUENCY TOLERANCE OF 4.6ppm OVER TEN YEARS SURFACE MOUNT PACKAGE TAPE AND REEL PACKAGING TABLE 5.0 Surface Mount, Non-hermetic package consisting of a n FR4 substrate with grounded metal cover. TABLE 6.0 The component solder used internal to this device has a m elting point of 221C. The peak temperature inside the device should be less than or equal to 220C for a maximum of 10 seconds Ultrasonic cleaning is not recommended PROCESS RECOMMENDATIONS Solder Reflow ORDERING INFORMATION Wash Notes: BSOV3S3 - 12.80MHz OCXO SERIES CENTER FREQUENCY Initial calibration @ 25C, Vc=1.59 Vdc. Frequency vs. temperature stability At the time of shipment after48 hours of operation. Inclusive of calibration, operating temperature range, supply voltage change, load change, shock and vibration, 20 years aging. 5) Measured @ 25C, within 5 minutes, the unit will be within +/-0.1ppm of its reference frequency, measured after 30 minutes of contin uous operation at a stable 25C 6) Referenced to Fo @ 25C, Positive Transfer Characteristic 1) 2) 3) 4) Specifications subject to change without notice. DATA SHEET #: Cx032 PAGE 1 OF 2 REV: 03 DATE: 11/12/04 aCopyright 2001 Connor-Winfield all rights reserved. THE CONNOR-WINFIELD CORP. 2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 851-5040. PHONE (630) 851-4722. www.conwin.com PRODUCT D ATA SHEET CRYSTAL CONTROLLED OSCILLATORS ENVIRONMENTAL CHARACTERISTICS Temperature Cycle: Per MIL-STD-883, Method 1010, Condition B. -55C to 125C, 20 cycles,10 minute dwell, 1m inute transition. SOLDERING Pad Solderability: Per MIL-STD-883, Method 2003. 8 hour steam age prior to 245C 5C Solder pot dip, 95% Coverage. Solder Reflow: The component solder internal to this device has a melt ing point of 221C, the peak temperature inside t he device should be less than or equal to 220C for a maximum of 10 seconds. MECHANICAL CHARACTERISTICS Vibration: Per MIL-STD-202, Method 204, Condition A. 10G's peak, 10Hz to 500Hz, 15mi nute cycles 12 times each perpendicular axis. Shock: Per MIL-STD-202, Method 213, Condition D. 500G's, 1ms, half sine, 3 shocks per direction. Moisture Resistance: Per MIL-STD-202, Method 106. 95% RH @ 65C, 10 cycles 10C to 65C. PIN FUNCTION .330 max (8.382mm) CW DATE CODE BSOV3S3 12.80M 1 7 8 14 CONTROL VOLTAGE GROUND (CASE) OUTPUT Vcc Dimensional Tolerance: .005 (.127mm) KEEP OUT AREA 90% .830 (21.08mm) 50% 10% .565 (14.35mm) CONTROL VOLTAGE 3.0Vdc POWER SUPPLY 3.3Vdc 14 8 1 7 Specifications subject to change without notice. DATA SHEET #: Cx032 PAGE 2 OF 2 REV: 03 DATE: 11/12/04 aCopyright 2001 Connor-Winfield all rights reserved. |
Price & Availability of BSOV3S3-1280M
 |
|
|
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
| [Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
|
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |